But this is false massage.
There is no 3 pin connector, isn't it?

today i want to clear airbag errors in my punto II 1.8 HGT.

i have FES 2.7.2 and get this: "your car has 3 pin connector..." and i can not connect to airbags in this 2.7.2 version.
old FES 2.6 works fine and i've cleared errors now.
it looks for some BUG in FES 2.7.2 or maybe even FES 2.7

also I tryied to test my interface inside FES and these are the results : COMMAND: ATBI RESPONSE: CAN ERROR COMMAND: ATZ RESPONSE: ELM327 v1.3a looks like it's not working in CAN but I have resistors and capacitors in the right place.. what does it mean.. :( :evil: you should try to remove this two...

i have bought ELM 327 1.4+ as on picture downside. :mrgreen: this device was alredy modified for Fiat. there were changes like on picture below. i check resistor and they were 100 Ohm both. i have no multimeter to check capacitors. but there was a problem. each time i plug this interface into my car...

I can not check (switch on) overheat warning lamp.

I have the same. Punto II HGT 1.8 16V 11/2000.

Max 12500rpm in 69sec ROTFL