It's in this thread: viewtopic.php?f=5&t=1493

wrinx

Success! My lead was purchased with a jumper switch already installed (by Sander). Because it worked ok on my 156 I didn't think it needed switching for the Brera...but it does :roll: Fault codes cleared and played with a couple of sensor lights :lol: Great software, thanks...now what shall I do wit...

No, I'm assuming the KKL is ok because it works fine on my 156.

I think it's a good quality KKL, came from a reputable source anyway.

Should I still try another, could you recommend one?

wrinx

The plot thickens...I'm unable to connect with one of those generic hand held code readers either, yet the proper Alfa diagnostic at the garage works

Any ideas?

wrinx

No-one else having problems with a Brera...or perhaps I should be asking if anyone HAS connected to a Brera with the standard KKL interface?

wrinx

Thanks Yani.

Yes, I was trying to connect to the engine only...this is the 2.4 JTD (200bhp) which should be ok I think?

wrinx

No-one...?

wrinx

Should have said...using v. 2.7.2.

wrinx

Hi All

Does anyone have experience or suggestions for a non-communicating Brera?

I changed the COM setting and the program (KKL cable) works fine on my 2001 156, but nothing on the Brera???

wrinx