Fiat Punto 1.2 8v 2003 (Mk2 not Mk2b) Problem: Lumpy misfire when cold, but doesn’t return any error codes to try to track down which cylinder. I found an American site that mentions "mode 6" for seeing misfire counts. It says there are set numbers of misfires before it registers an error ...

if it is too much, you can connect pin 1 + 3 + 7 and than you can start multiecuscan program and then you can connect to ECU (airbag + engine)! but this is not recommended... P.S. did you check AIRBAG contact below you seats? Alfa156 There were 2 error codes stored both for passenger squib. One cle...

yes you have to cut the wire shown on photo by davan cut this wire! when you cut this wire you will get left side of cut wire and right side of cut wire. Connect pin 3 with left side of cut wire and than you can connect to AIRBAG ECU! p.s. davan sorry for copying your photo![/quote] Thanks Alfa I to...

Hi all Complete novice here. I have just taken delivery of one of these: http://cgi.ebay.co.uk/USB-409-1-KKL-VAG-COM-OBD-2-II-VW-AUDI-SKODA-SEAT-Cable_W0QQitemZ190329451002QQcmdZViewItemQQptZUK_Diagnostic_Tools_Equipment?hash=item2c5084f1fa I have read all the posts, but still can’t understand how t...