I found a log for a similar transmission showing I don't normally have a problem. (Multiecuscan 4.6R1) 18/06/2020 10:58:01 Fiat 500 1.4 Turbo 16V T-Jet/MultiAir Abarth Marelli SELESPEED CFC319 Automatic Gearbox -------------------------------------------------------------- ECU ISO code: BC 07 23 8A ...

Thanks for the reply, I have found the logs you refer to. The first one shows the parameters reading whilst warming up and the second one shows the calibration request. If it helps.. The request makes the car able to select first or reverse and pick up drive correctly but returns to fully inoperativ...

Clutch calibration problem. Cantiecar interface on USB or BT. New clutch and slave fitted to 2014 1.4 500L reset clutch data OK DTC final clutch calibration enable set. Temps OK select final clutch calibration, start engine press Y ------- timeout, loses comms returns to main screen without status r...

fixed....
BCM was not compatible with Airbag module.

re-fitted original BCM + ECU then do Proxi-alignment and clear airbag fault.
Swap ECU data into replacement ECU.

Ducato 2.3 2009 (Iveco engine) ECU and BCM changed because of faulty ECU. Van starts and runs fine. Mileage flashes. Connect multiplexed cantiecar with 2.7 software to do a Proxi-Alignment. Carry out alignment.. result says OK but Airbag light stays on. Airbag fault = B104A PROXI Alignment Procedure...