Hi I retrofitted remotestart with learned additional 5-btn key also... Programming was done succesfully but car wont start, but starting procedure works well (car honk twice, then run the cluster and then shut down in a second with message " Remote start dissable, start engine for reset" a...

Hi which bulbs did you swap? Main lights or high beam?
You can turn off the bulbchecking.
Share your proxistring here and I will take a look on it...
regards

hi,
Main problem is in proxi configuration, your airbag module (ORC) asks for specific settings.
Check feslog file after proxi alignment and read which value is ORC asking for...
...and release all seatbelts before alignment

Or share feslog for check...

Hi this is hard theme.
I tried to retrofit cruise control, wiring and coding but I was stuck.
Cruise control didnt work. So I uninstalled lever. Lever was from fiat 500.
But in BCM unit was shown error message "cruise control lever signal"

Hi share your proxi string because without seeing bytes we are not able to fix your problem.
The best way is load whole FESlog file or copy/paste it here on the board...

Regards

Hi guys,
Do you have FULLLEDS retrofitted already?
If you are able to share your proxi string I will look on it and maybe it could be possible to run correctly.

Regards

Hi run multiecuscan, install sgw bypass,
Ser 500X than body and adjustment
Set rearview camera to enable
Run proxialignment procedure
Follow instructions
Thats all

Hi!
Your engine is the same as in Tipo 500X Renegade Compass etc...
So connect via other type of car...

Did you use adapters on light connectors?

You have to change proxi and enable LED management...

Hi!
Dont worry parking control module will be after retrofit automatically added into system an all you have to do is run proxi alignment procedure.
If you will do only rear sensors you wont need anything else, but if you will added also front sensors then change value on byte 118 to 10.

regards