Multiecuscan

Thank you Alfaeddy, I will try to remove that part and I will let you know.

Regrads

Hello

Remove nothing

Make a picture of this place

Greetings Eddy

Your ELM is the same as here on Alba_Skye
this did not interfere with this resistance of the CAN connection
compare it some

viewtopic.php?f=5&t=1493&start=120

There fore your ELM work without rebuilding.

Greetings Eddy

Yes, it is same as Alba_Skye. OK.

qualcuno sa dirmi perchè non va questa elm? non funziona con nessun programma . ho tolto anche la R04 ma niente. scantool non la riconosce ,
FES mi dice che è una versione 1.0 e che non si collegherà a nessuna linea CAN.
forse perchè è rossa?

Hello

The reading of the data is very time critical, and the resistance between the two
CAN Cables changes time

Why this interface with other software but do not function with Multiecuscan (multiecuscan), I can not say exactly.

Anyway, the poor resistance R04 still present on your board.
The yellow circle sits the R04

Greetings Eddy

Alfaeddy wrote:Hello

The reading of the data is very time critical, and the resistance between the two
CAN Cables changes time

Why this interface with other software but do not function with Multiecuscan (multiecuscan), I can not say exactly.

Anyway, the poor resistance R04 still present on your board.
The yellow circle sits the R04

Greetings Eddy

grazie Alfaeddy la reistenza è eliminata ma il problema non credo sia quello.
si può provare a fare la modifica di Yani cambiando le altre resistenze o forse è un problema del chip?

Hi I have the red version is
R04 removed
removed r14
CANbus network can not see does not work.
What is the solution can anyone answer?

I think if you remove R04, you must add the sets R32/R33 C8/C9

Krg wrote:I think if you remove R04, you must add the sets R32/R33 C8/C9

Thank you very much KRG but unfortunately I can not be connected from the image. Can you help me because they are not in the same box. Mine v1.4