Multiecuscan

Hi I have a Fiat 500 from 2018. It starts and for 5 seconds and stop. if I hold the accelerator it stays started for about 20 seconds. I put back a blank calculator which was autocode and I have same problem.
Any anyone know the problem?

Thanks in advance.

Any fault codes stored?

Problem solved, an massa broken in car.

It's back from thief. So we have changed the BCM with second hand because original is missing.


I have virgin ECU motor, adapter to car.

Now i have mil blinking in dashboard due to proxy aligment. I have do it but i have always error on the ETM (entertainment telematic node).


How can i do to make working?

Regards,

You can obtain the original radio code via the interweb, quite a few websites who do radio codes.

Can you upload the current proxy?

I have pin code of the radio.

I have changed the bsi.

This is the log and hex proxi backup.

Only error with ETM when doing allignment?

Yes

And any fault codes in ETM?

Thanks for all help.
Car startnow.
I have make some reset on ecu.

About proxy bytes. I have copy an proxy bytes from a thread on forum and now all work good now.