Multiecuscan

Speedometer replacement due to AdBlue

The old speedometer only had a warning light for AdBlue.

The new speedometer has an AdBlue tank gauge.

Proxy alignment not possible

An error message appears

The motorhome does not have PDC (Park Distance Control)

However, PDC appears on the new speedometer

Is it possible to delete the PDC?

Old speedometer: 503.016.020.322
1395350080

New speedometer: 571.016.020.132
00468644540

Exchange

After an failed proxy you can press a little pdf button on the botom right corner of the MES homescreen. Post the results of that pdf here.

As requested, here is the PDF.

Speedometer recalibration worked.

All error codes were cleared.

Unfortunately, the AdBlue tank gauge has become a temperature gauge.

Which byte code is responsible for this?

And how does it need to be reprogrammed?

Here are the proxy details.

30 38 32 35 30 34 33 34 30 33 31 4F 55 54 50 55 54 44 4A 49 54 20 20 02 22 4B 18 40 04 00 02 00 00 09 00 00 04 00 00 00 00 03 40 53 08 B1 00 AB 20 00 00 00 16 00 00 00 8C 06 0B 02 60 C0 02 D6 04 05 00 05 04 00 00 00 00 56 00 00 00 00 36 00 D3 03 11 34 00 98 00 AD 00 A0 10 00 00 00 00 00 C0 00 00 00 00 00 00 00 00 00 64 00 00 00 00 00 00 85 17 00 04 00 00 00 40 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 40 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 10 00 00 00 1F 00 00 04 20 00 02 FF