Multiecuscan

Hi all,

My car is a Stelio V6 quadrifoglio 2018. I have changed the solenoids in the gearbox 8HP. I have an error when I want to execute the action "Actuator Base Adjustment". The error message is « request out of range error« . I respect all the procedure described : engine running ... I was thinking about the SGW but I am able to launch successfully the option "self-adaptation reset" wihout any issues. I am also able to update the service interval ...
Do you think it is the SGW ? I had in mind that you cannot do anything if you have SGW ...

Thanks in advance for your help
Rom1

If you do a full scan, MES will say if an SGW is detected.