Multiecuscan

Hello!

I Have a problem after Proxi procedure in Panda. After procedure external temperature indicator disappeared from dashboard? Does anyone know why and how to fix it?

I saw in another thread that you actually changed the Instrument Cluster and the temperature does not show on the new one. Is this correct?

Yes I've changed the Instrument Cluster.

After I changed it it there was temperature in this new one but the milage indicator was blinking.
Then I did Proxi and temperature disappeared.
Any idea how to fix it?

Did the old instrument cluster show correct temperature?

The old one was basic version without temperature and RPM-meter. I borrowed also the third one with temperature and it is working well but the odometer is blinking because I haven't done proxi yet because I'm afraid that the result could be the same.

Ok, I understand now...
Can you find the log file from the proxi alignment and send it to me (in PM).

In the future it will be able to make a proxy on the counters from gasoline to the diesels?

No, it is not possible to exchange instrument cluster between diesel and gasoline. It is a limitation of the firmware inside insrument cluster (and in most cases there are physical differences).

I understand that in the other direction is the same?

same thing with temperature happened to me. It might be that Body Computer says there's no temp reader and instrument cluster gets this information while proxying so It turns the option off. Is there any fix for that already? Also Yani, are you planing to add milage fix, so that instrument cluster shows the milage stored in Body Computer? I'm not sure how they'll react on car test if they found that in between 2 years car changed milage from 80000 to 15000