High Latency Problems
Posted: 08 Apr 2014, 14:37
I have a registered version of MeultiEcuScan ver 1.9 however I am having trouble connecting to the CAN
Using the Port Scanner in Settings I get the following
It has been suggested that I get a yellow adapter cable which I did, but that made no difference.
I then downloaded EasyOBD to test it, and without the yellow adapter it works fine, with the yellow adapter it fails to comunicate with the car.
If I try to connect to the engine, using MultiEcuScan, that works fine.
Anybody any thoughts?
Using the Port Scanner in Settings I get the following
Code: Select all
Scanning ...
ELM 327 1.3+ interface found at port COM5, speed 38400bps
This interface is compatible with ELM 327 1.4! Should connect properly with all CAN modules.
Latency Too High!!!
COMPLETEDI then downloaded EasyOBD to test it, and without the yellow adapter it works fine, with the yellow adapter it fails to comunicate with the car.
If I try to connect to the engine, using MultiEcuScan, that works fine.
Anybody any thoughts?