Multiecuscan

Hi everyone,

I have a real elm327 and an officially registered Multiecuscan..

I can connect on the can bus to the body computer and there i can select add remotecontols..

After entering my cars pincode it says, press Y and after that press any key on the remote to learn it.

As soon as I entered Y it says "FUNCTION UNSUPPORTED".

I bought the program cause it said it fully supported my body computer.. Please guys help me out…

All settings are correct and there is no high latency.. Regards John

Contact MES support directly.

Also use the "Send Report" button (lower right of screen to the left of the MES logo) to send a report.

Hi S130,

Thanks for your reply!

I did contact MES support twice, but not using the button you suggested!

So I will give that a try, regards John