ElmSCAN 5 Timeout

[Tanis8472]

Hi guys,

I've just bought ElmSCAN5 with OBDWiz from Scantool-Direct.co.uk.
I cant seem to test the Elm from within FES. Does it have to be plugged into a OBD in a car to test it?
Drivers are installed from the disk.
It always tells me

COMMAND: ATZ
The operation has timed out.

I have settings set to 115200 in FES and port settings, as its a V1.4 ELM

Help please

[yani]

Try with different port speed.

[Tanis8472]

Port speed where?
COM Port or FES or both?

[alfa156sarajevo]

...It always tells me
COMMAND: ATZ
The operation has timed out...

I have this problem when the interface is not connected to the car.
when I connect interface with the car it gives me all info’s:

COMMAND: ATZ
RESPONSE: ATZ ELM327 v1.4a>

COMMAND: ATE0
RESPONSE: ATE0OK>

COMMAND: ATL0
RESPONSE: OK>

COMMAND: ATH0
RESPONSE: OK>

COMMAND: ATSPC
RESPONSE: OK>

COMMAND: ATS0
RESPONSE: OK>

COMMAND: ATCAF0
RESPONSE: OK>

COMMAND: ATCFC0
RESPONSE: OK>

COMMAND: ATCRA 7B0
RESPONSE: OK>

COMMAND: ATSH 7B0
RESPONSE: OK>

COMMAND: ATAT1
RESPONSE: OK>

COMMAND: ATST41
RESPONSE: OK>

COMMAND: ATBI
RESPONSE: OK>

COMMAND: ATZ
RESPONSE: ELM327 v1.4a>

[EnIgMa]

...It always tells me
COMMAND: ATZ
The operation has timed out...

I have this problem when the interface is not connected to the car.
when I connect interface with the car it gives me all info’s:

CUT

it's not a problem, elm device need electricity so it's powered by the car, not from the computer.